Pine Tide videos usually have one problem: the audio is longer than the story. A walk along the shore, a voice note recorded on the spot, a clip that starts before you were ready — the footage is good, but the sound needs a trim before it belongs in a video.
Step 1: Open AudioCutter in your browser
Open AudioCutter and drop your file in. There is nothing to install and nothing to upload — trimming happens on your own device, so your recording never leaves your computer. It works with MP3, WAV, M4A, and other common formats.
Step 2: Cut the dead air first
Drag the handles to remove the silence at the start and the trailing noise at the end. Listen to the cut points: the clip should begin on a real sound, not on a breath or a rustle, and end before the audio wanders.
Step 3: Keep only the best minute
If the recording runs long, pick the strongest section instead of trying to save everything. A tight sixty seconds of clear audio will hold viewers far better than five loose minutes.
Step 4: Export and add it to your video
Export as MP3 to keep the file small, or WAV for maximum quality, then lay the trimmed clip under your Pine Tide footage. Save the original file separately so you can cut a different version later without re-recording anything.
Two small habits make a real difference: always listen to the first and last two seconds before exporting, and use a short fade at both ends so the clip never starts or stops with a click.
Disclosure: I'm the developer of AudioCutter, a free online audio cutter at https://audiocutter.me/. I built it to make trimming audio quick and private — your files never leave your browser.


