If you're preparing for an RTL, verification, or memory interview, you've probably memorized what tRCD stands for. The follow-up question is the hard one: what is the silicon actually doing during that wait? Once you see that every timing parameter is analog physics with a digital name, you can rebuild most of the rules from scratch.
Start with the cell
A DRAM bit is charge on a tiny capacitor, connected to a bitline through one access transistor. Reading it works by charge sharing: the bitline is precharged to VDD/2, the wordline turns on, and the small cell capacitor nudges the much larger bitline up or down by roughly 100 mV. A sense amplifier then amplifies that difference to full rail, and in doing so writes the value back into the cell, because charge sharing destroyed it.
Every core timing parameter protects one step of that process.
The parameters, one physical cause each
| Parameter | Rule | What the silicon is doing | DDR5-4800 typical |
|---|---|---|---|
| tRCD | ACT → RD/WR | Charge sharing plus sense-amp latching | 16 ns |
| tRAS | ACT → PRE | Sense amp finishing the restore into the cells | 32 ns |
| tRP | PRE → ACT | Bitlines equalizing back to VDD/2 | 16 ns |
| tRC | ACT → ACT, same bank | One full open-restore-close cycle (tRAS + tRP) | 48 ns |
| tWR | Last write data → PRE | New data reaching the cell capacitors | 30 ns |
| tRRD_S / _L | ACT → ACT, other bank | Activate current spikes: protecting the power grid | 8 nCK / max(8 nCK, 5 ns) |
| tFAW | ≤ 4 ACTs per window | Same power limit over a longer window | device-dependent |
| tCCD_S / _L | Column → column | Bank groups share internal data paths | 8 nCK / max(8 nCK, 5 ns) |
Two of these trip people up. tFAW and tRRD are not logic delays. Every activate fires a whole row of sense amplifiers at once, a big current spike. Too many in a short window and the internal supply droops. The _S/_L split exists because of bank groups: banks in the same group share prefetch circuitry, so same-group operations need more spacing.
The classic whiteboard question: tRRD_L in clocks
DDR5-4800 means 4800 MT/s. Data moves on both clock edges, so the clock is 2400 MHz and tCK ≈ 0.4167 ns.
The rule is max(8 nCK, 5 ns). 5 / 0.4167 = 12, so tRRD_L = 12 clocks, not 8. Hard-coding the "8 nCK" you see in a table is an easy bug that every test written from the same assumption will happily pass.
Want the one-page version?
I put every core DDR5-4800 parameter on a free printable cheat sheet: the rule, the one-line physics, the typical value, and the clock count. Grab it free here.
Values are typical published figures for DDR5-4800; always check your device datasheet and JEDEC JESD79-5. Drafted with AI assistance and reviewed for accuracy.